Reinstatement of Context During Sleep and Its Subsequent Effect on Memory: an fMRI Study

Each participant will be run in a single afternoon, which includes a 90-minute nap opportunity. This study will be divided into three continuous sessions. The first and third sessions will be done inside the MRI scanner, whereas the middle session will be conducted outside of the scanner, while recording electrophysiological data. The crucial manipulation involves the careful control of temporal context, which is accomplished by preserving the temporal order of trials during training and using spatial scenes as markers of context. This is a within-subjects study. The main manipulation is the unobtrusive presentation of sounds during sleep, a technique called targeted memory reactivation (TMR). All participants will hear these sounds, but the specific sounds each one will hear will be different. The results will then be compared within participant, not between different groups or individuals. Appropriate statistical methods for such analyses include paired t-test and repeated measures analysis of variance. The choice of which sounds will be presented to each participant will be made based on their performance in the pre-sleep test. This will be done in an attempt to balance pre-sleep scores between presented and unpresented stimuli to remove statistical noise. Both the participant and the experimenter will be blind to which sounds will be presented, and the selection will be automatically made by the computer. This technique has been extensively used and has no known risks. There are two main reasons that using a within-subject design reduces the required sample size. First, the lack of a between-subject independent variable intuitively requires less participants. Second, the level of statistical noise due to individual differences is reduced (i.e., because each participant is compared with their own scores). Previous TMR studies, which have found significant cuing effects, commonly used 20-25 participants. I plan to include at least 30 participants in this study, after omitting participants who could not complete the task and those who were not sufficiently cued during sleep. Having 30 participants will allow the use of more powerful statistical methods (in accordance with the common rule of thumb derived from the central limit theorem, which states that means based on sample sizes of more than 30 participants can be assumed to follow a normal distribution). I expect the context-related TMR effect (see summary) to be smaller in magnitude relative to the common effect size observed in spatial learning TMR studies (Hedge's g = 0.39 based on a recent meta-analysis15). This is why I included a higher sample size. It is important to note that even if this benefit will be of a smaller magnitude, as I expect, it will still be indicative of the underlying neurocognitive process and therefore extremely valuable for our mechanistic understanding of the role of context in sleep. Aiming at a sample size of at least 30 participants and assuming an omission rate of 80%, I therefore plan to have 38 participants altogether. Here is a brief summary of the procedure: Stimuli: 12 images of spatial scenes (e.g., a beach) will each be arbitrarily associated with five smaller images of objects or animals. As described later, half of the scenes will be associated with a right hand motion and half with the left - and half of each of these groups will be cued during sleep. Each of the 60 images will each have a unique 2D position on a circular grid presented on the screen and will be accompanied by a specific, congruent sound (e.g., cat - meow). fMRI Localizer: After the participant is first put in the scanner and a basic anatomical scan is complete, they will be exposed to all the different scenes while being scanned. This will later be used to classify scene-specific blood-oxygen-level-dependent (BOLD) responses. Training: First, participants will learn to associate scenes with a hand motion. They will repeatedly see each scene on either the left or right side of the screen and be asked to imagine touching the image on the projected screen. In this and every following training block, the scenes will be presented in a participant-specific, non-randomized order. Next, participant will be exposed to all 60 images' locations on the grid and asked to associate the image with the scene and remember the location. The images for each scene will consistently be presented in the same order within the scene, and therefore the order of the 60 images will be maintained throughout training. The left/right sides of the screen will be used for each scene in accordance with its designated hand in the previous training stage. After two rounds of exposure, participants will go through a similar positioning phase of training. They will be shown the image and the scene and asked to associate them. Then, they will see the circular grid without the image on it and asked to imagine touching the correct location with the appropriate hand. The next screen will show the image in its correct location and ask participants to signal whether or not they knew the location. The next image will be presented after a short inter-trial interval. An image's location is considered learned when it was marked as correct twice in a row. Blocks will be repeated in the same order until all locations are learned. For the images which were already learned, the repeated block will employ an alternative task to avoid over-learning while maintaining the temporal order of items. Pre-sleep test (in scanner): After training, participants will be presented with all images in a pseudo-random order and asked to imagine touching their correct location on the grid with the appropriate hand. Pre-sleep test (EEG): Outside the scanner, the participant will be fitted with an EEG cap and then asked to take another test. Here, images will again be randomized and participants will first be asked to imagine touching the correct location and then ordered to actually touch the correct position. Subsequent measures of change in spatial memory will be based on the performance in this test. Throughout the task, the act of imagining the hand motion is not used to decode the exact position on the screen in which the participant thinks the item should be located. Instead, imagined hand motion will serve as a rough measure of hemisphere specific reactivation, that will then be used to classify reactivation during sleep in the EEG, as done in 64. Although this decoding will primarily be done using EEG and not fMRI, the instructions to imagine hand motion are the same for all phases of the experiment in order to maintain consistency throughout the task. Sleep: During NREM (non-rapid eye movement) sleep, the sounds associated with specific images will be presented unobtrusively. The scenes from which these images will be chosen will be half of the right- and half of the left-handed ones. For each of these scenes, one image will be cued, positioned in either the 2nd, 3rd or 4th place in that set's training sequence. The choice of which sounds to present will be made in a manner that will balance pre-sleep results and therefore enhance the contrast between sleep-related effects for cued and non-cued images. Post-sleep test (EEG): At least 10 minutes after the end of the nap, participants will start this test, which will be identical to the Pre-sleep test (EEG). Post-sleep test (in scanner): Identical to the Post-sleep test (in scanner). Scene-image association test: Finally, participants will be shown each image in a randomized order and asked to indicate which of four presented scenes is associated with it. fMRI Localizer: Same as the first. Participants will finally be thanked, debriefed, paid and dismissed.