H-Type Hypertension Precision Medicine Trial

Phase I: Screening（V0） Phase I takes place for about 2-10 days. The purpose is to obtain informed consent and make a preliminary assessment of the patient. At the first screening visit (V0), or prior to the official treatment visit, a clinical examination will be performed to determine the patient's clinical diagnosis and to determine eligibility for inclusion in the study. General demographic information and questions related to the inclusion/exclusion criteria of this study will be obtained. Additionally, this will be the time to discuss the impact of participant vacation/travel plans on adherence and compliance with the trial protocol. Before carrying out any research procedures, the purpose of the study and study procedures will be explained and the participant's informed consent will be obtained. Clinical Diagnosis and Assessment: Prior to the start of the Run-in Period, baseline data and efficacy evaluation data will be collected according to the study flow chart; blood and urine samples will also be collected. Blood Pressure Measurement: A unified electronic sphygmomanometer blood pressure measurement will be obtained. Participants will be prohibited from smoking, drinking coffee or tea, and urinating 30 minutes prior. Before taking the measurement, participants will be asked to sit quietly for at least 5 minutes prior; the participant will then be asked to assume a sitting position, with both feet flat on the ground and the upper right arm exposed and at the same height as the heart. After measurement, the sphygmomanometer will display the blood pressure and pulse. The average of 3 consecutive measurements with 1-2 minutes between each measurement will be taken and recorded. The median of 3 pulse measurements will also be recorded. Laboratory Tests: Female participants of childbearing age must undergo a pregnancy test prior to the run-in period. Based on clinical indications, the investigator may also decide to conduct a pregnancy test at any time throughout the trial as needed. All participants will be asked to complete the following laboratory tests: 12-lead ECG, urinalysis, blood biochemistry, folate, and Hcy assessment during the screening period. All results will be obtained prior to the run-in period visit. Phase Ⅱ: Run-in Period (V1-V2) All eligible patients will begin a treatment of enalapril (10mg/d) for a 0 to 2-week open induction period, during which time other antihypertensive drugs may also be concurrently used. MTHFR C677T genotype will also be determined during this phase. The primary purpose of this phase is to assess participant compliance to the enalapril treatment regimen as well as to observe the participant's tolerance to enalapril, so as to avoid including those participants with poor compliance or intolerance to enalapril to the double-blind treatment phase. Newly diagnosed hypertensives should be given enalapril during the run-in period and can be given other antihypertensive drugs at the clinician's discretion. For hypertensive patients currently using medication, if not currently using enalapril, the clinician should, based on the patient's medical condition, add or switch the patient's medication to enalapril. Hypertensive patients demonstrating good tolerance and adherence to angiotensin converting enzyme inhibitor (ACEI) drugs and who have already been genotyped for MTHFR C677T polymorphism may pass over the run-in period and directly enter the double-blind randomized treatment period. Phase Ⅲ: Double-Blind Treatment (V2-V6) The third phase consists of 8 weeks of a randomized, double-blind treatment. Patients who remain eligible for participation in the study will first be stratified by gender and MTHFR C677T genotype (CC, CT, TT), for a total of 6 strata at the start of V2. Each of the 6 strata will then be randomized into 8 treatment groups: either enalapril only (10mg), or one of the other 7 treatment combinations with various doses of folic acid. During the 8-week double-blind treatment period, other antihypertensive drugs can be combined with the treatment drug to achieve blood pressure control; the patient will be followed-up every 2 weeks during the treatment period, and the treatment drug will be distributed at each visit. During this period, participants should continue to avoid taking medications that may interfere with the evaluation of treatment efficacy. For participants who complete the run-in period and are eligible to remain in the study, a randomized treatment allocation list will be generated using a stratified, block-wise, randomized approach by MTHFR C677T genotype and gender. This list will assign a unique study ID to every study participant. The ID corresponds to a specific treatment allocation; this ID assignment determines the treatment type the participant will receive. This study will use a two-level blinding procedure. The first level of blinding will generate a randomized sequence table corresponding each study ID to one of the eight different treatment groups. Each treatment will be given a treatment group code (from a to h) so that the actual treatment cannot be identified from this table. The second level of blinding will denote the type of treatment that corresponds to each of the eight different coded treatment groups (a through h) that were generated from the first level of blinding. The randomized ID's will be generated by a statistical analysis group; the blinding program and all electronic documents regarding the level one and two blinding will be sealed in separate envelopes and protected by the sponsor. The seal cannot be broken before the trial officially undergoes the unblinding process. In addition, the research drug management center will maintain a copy of the treatment allocation list and will be responsible for encoding the treatment drugs and dispensing the medications to the participants based on the treatment allocation list.